2N Lift8 v1.6.0 - Manual (Page 187)

187
2N TELEKOMUNIKACE a.s., www.2n.cz
®
and configuration. You can use multiselect to change (delete, export) parameters for a
higher number of intercoms: either hold Ctrl to select the objects or hold Shift to select
the first and last objects thus selecting all the objects between them. All the changes or
exports made over the selected intercoms will apply to all of them.
Intercoms
Select an intercom to open an extensive menu level with intercom identification forms,
check call evaluations, maps and local plans of the building where the intercom is
installed. Let us describe each of the forms.
General
The form helps you configure general parameters for an intercom. The first General
row defines the Authorisation state of the selected intercom. All the intercoms added
manually to the database or created automatically and confirmed as real intercoms are
authorised. Contact number provides the
identification. makes check CU 2N Lift8
®
calls from this number and makes active check calls to this number: 2N Lift8 Server
®
enter either a SIM card in the , number of the PSTN line to the intercom or number CU
of the PBX/gateway behind which the intercom is located. Type defines the type of
device:
, , or . Refer to the 2N LiftNet
®
2N SingleTalk
®
2N Lift8
®
Unknown
Intercom Creation subsection above for details. Name defines the intercom name. Set
a name equal to the contact number for an automatically created intercom. Intercom
identification is primarily used by the CPC a P100 protocols for counterparty
authorisation. As identification is not set automatically during creation, complete the
value to make the two protocols work properly. In the case of check call
rejection/confirmation with a DTMF character, this parameter is not checked off. Enter
the address of the building in which the intercom is located into the Address field to
display this information on the map used by Technician for repairs or Dispatcher for
rescue team navigation. Fill in brief information on the intercom to be installed in the
Description item: location, purpose, specific settings and so on.