2N Lift8 v1.6.0 - Manual (Page 71)

71
2N TELEKOMUNIKACE a.s., www.2n.cz
®
1.
2.
3.
4.
5.
6.
Volume Setting
Insert the hexagon key wrench (included in the delivery) in the hole on the
product bottom edge (window lock screw) and turn
(about 10 times) until left
you feel resistance.
The window slides down by itself or with a slight aid, revealing its upper brim.
Tilt the window forward and remove it.
Set the required volume level using a trimmer.
Replace the window.
Insert the hexagon key wrench (included) in the hole on the product
bottom edge (window lock screw) and turn
(about 10 times) right
until the window slides under the panel edge. Tighten slightly.
Mounting Completion
Having connected the wires, complete the cabin wall mounting. If you can access the
lift wall from the outside, the Installation is easier and the audio unit cannot be stolen
as its screws are not accessible from the cabin. If you can access the cabin wall from
the back side, follow the instructions in item a) or b). If not, obey the steps in item c).
Caution
Use the trimmer to set the best acoustic properties eliminating
feedback.