Device, Recording settings, Info – 2N Lift8 v1.6.0 User Manual
Page 161
161
Recording Settings
Find the
to the left. Select one of the available input devices in
Recording settings
Select source: integrated or external microphone or line input. Mic level defines the
microphone input drive level. Mic gain defines the input gain. The total memory
capacity for all the messages to be saved into the
is 8 minutes. The time left for
CU
message editing is displayed in the Time left parameter.
Device
The
menu provides information on the
connected:
Device
2N Lift8
®
Central Unit
basic parameters and text/graphic diagram of available Audio Units and splitters. In
addition, you can upgrade the
here too.
CU
Info
The
menu provides basic information on the state of the device connected:
F
Info
CU
W version, serial number, voice menu language and time. The Time in device
parameter displays the current time read from the
. This parameter is not read
CU
online and has to be updated using the Read from device parameter. Set time in device
helps you record a time setting of your own. Click on the calendar to set the date/time
in hours manually. This value can be overwritten and different time can be set for a
different time zone. Click Confirm to confirm the new setting. Click Save current time
from PC to device to synchronise the
time with your PC time value and load the
CU
new setting into the
automatically.
CU
The Password section helps you change the administrator password for the
connect
CU
ed. Enter the existing password into the Current password and the new password into
the New password. Click Save password to device to confirm and save the new setting.
Caution
The output volume value in the application does not affect the master
volume of the record to be saved into the
. Thus, if the recorded
CU
volume is too low, record the message once again and louder.
Tip
Use high-quality microphones and properly noise-insulated rooms with
good acoustic properties for recording to avoid noise and interference in
your records.
Note
If the microphone input is overdriven during recording, turn down the mic
input gain. If the record is too silent, turn up the mic input.
In case the application gain setting is not sufficient, use the system
controllers or an external amplifier.
When the maximum message time (8 minutes) is exhausted, no more
messages can be added. Thus, optimise the message time to record all of
your messages.