2N Lift8 v1.6.0 - Manual (Page 185)

185
2N TELEKOMUNIKACE a.s., www.2n.cz
®
A red handset above the icon indicates that the intercom failed to make a
check call within the timeout and is thus marked as non-functional.
When the intercom makes a correct check call, this state will disappear.
A yellow handset above the icon signals that the intercom made a check call
within the timeout but the first call was not accepted OK. This happens when
the first call was terminated for some reason, but the following calls were OK.
When the intercom makes correct check calls within the check call timeout,
this state will disappear.
A yellow question mark signals an intercom that was created by a check call
but has not been confirmed by Administrator yet as a real intercom. Refer to
the Intercom Creation subsection below for details.
This symbols a functional intercom: , , 2N
®
SingleTalk 2N
®
LiftNet 2N
®
or , probably supplied by another manufacturer and able to Helios Unknown
communicate with the via CPC / P100. 2N Lift8 Server
®
A functional intercom. The red chain below the icon indicates the 2N Lift8
®
state between the and the Central Unit. This Disconnected 2N Server
®
function is under development and will be available in later versions.
A functional intercom. The blue chain below the icon indicates the 2N Lift8
®
state between the and the Central Connection established 2N Server
®
Unit. This function is under development and will be available in later
versions.
Intercom Creation
Add an intercom to the database as follows:
The first way is to install a and configure it to call the number that the server uses CU
for check calls. When the makes the first check call to the server, a new CU
intercom card is created and basic information on the intercom is included: the
telephone number used for the check call is filled in as the Name. The so-created
intercom is marked as unauthorised to eliminate unintentional calls (telemarketing,
e.g.). To authorise this intercom, use the Basic tab for this intercom in the 2N
®
, which informs you that a new record has been created by a call from Control Panel
number x and asks you whether you want to keep it in the database or delete it. Press
Preserve to add the intercom to the database or Remove to delete the intercom from
the database if unintentional (telemarketing, error).
Tip
The is able to work with the third party equipment via 2N Lift8 Server
®
the standard communication protocols (CPC and P100) instead of
proprietary protocols. Set the type to Unknown to communicate with such
equipment.