2N Lift8 v1.6.0 - Manual (Page 127)

127
2N TELEKOMUNIKACE a.s., www.2n.cz
®
4.1 User Instructions
Cabin
The cabin audio unit is intended for an untrained user. Nevertheless, the instructions
can be placed in the lift cabin, e.g., to help the people trapped in the lift communicate
with the control centre.
Meaning of pictograms (icons)
The yellow Wait icon is illuminated while connection with the control centre is
being set up.
The green icon lights up when connection has been set up and confirmed by the
control centre.
The green icon lights up whenever TRIPHONY is in progress.
The blue icon does not shine, but marks the place where a signal is radiated
during the call for people with defective hearing equipped with hearing aids.
Shaft, Cabin Roof
Press the ALARM button to call the control centre using the ALARM 2 numbers
(parameters 021–026). If the parameter is not filled in, it calls the ALARM
numbers (parameters 011–016) like the cabin.
Pressing the TRIPHONY button to call the other audio units in the same lift
(shaft).
Hold the TRIPHONY button (for approximately 2 s) to retrieve the voice menu to
call the other shafts via TRIPHONY.
Re-press the TRIPHONY button to terminate this connection.
The ALARM button is illuminated in the standby mode.
The ALARM button flashes when a calling is being set up.
The TRIPHONY button is not illuminated in the standby mode.
The TRIPHONY button flashes and the green LED indicator is illuminated if
TRIPHONY is active between the lifts.
The yellow LED indicator is illuminated if connection is being made with the
control centre.
The green LED indicator is illuminated if connection has been made and
confirmed by the control centre.
Machine Room
Everything that refers to the shaft audio unit applies here too. Press (for longer
than 2 s) to display the . You can use the HandsFree machine room voice menu
mode or connect a handset to achieve better acoustic properties.
Having entered the voice menu, you can select the following functions using the audio
unit keypad.