2N Lift8 v1.6.0 - Manual (Page 65)

65
2N TELEKOMUNIKACE a.s., www.2n.cz
®
Before You Start
Requirements
Make sure that the lift wall is even.
Make sure that the installation meets the standard requirements (ALARM button
height and distance from the other lift buttons, e.g.).
Product Completeness Check
Check the product for completeness before installation.
1 Compact audio unit including: one long, 2 mm ballpoint hexagon key wrench4
M4×8 screws
symbol window
3 terminals slid on the backside connector
4 M4×30 worm screws
4 M4 nuts
4 fan washers
Mounting
Just drill holes into the cabin wall as shown in the figure below (also see the 1:1 figure
on the product box). The larger hole is intended for cabling. Round the hole edges to
avoid cable damage!