Volume configuration, Bus connection, Handset connection – 2N Lift8 v1.6.0 User Manual
Page 58
58
Bus Connection
Loosen the screws to the right and open the connector cover. There is just one
connector under the cover: a bus connector. Pull out the terminal from the connector,
connect the wires and replace the terminal. Make sure that the polarity is maintained.
Handset Connection
Order an additional handset for your
. The handset is delivered including a
audio unit
cable with telephone end pieces.
Testing
Connect a handset and push and hold for over 2 s
to display the voice menu for
the function test. If the handset does not work, the voice menu will be played from the
speaker.
audio unit
Volume Configuration
Open the protective door on the
and adjust the volume
.
audio unit
using the trimmer
Warning
Connection to different, e.g. higher-voltage, cables leads to damage or
destruction of the audio unit.
Maintain polarity while connecting the
to avoid
error
audio unit
audio unit
.
Caution
The
is powered via a 2-wire bus. Disconnection of these wires
audio unit
results in the
switch-off
audio unit
.
Caution
If the handset is not connected, the
works in the HandsFree
audio unit
mode.
A handset of a type other than that supplied by the manufacturer may not
work.