2N Lift8 v1.6.0 - Manual (Page 188)

188
2N TELEKOMUNIKACE a.s., www.2n.cz
®
Intercoms – General Menu Figure:
The Checking call period specifies the timeout within which the intercom must call the
r or after which makes active check calls. The 2N Lift8 Serve
®
2N Lift8 Server
®
intercom can call the any time within this timeout, but having 2N Lift8
®
Server
exceeded this value, it will be marked as defective. The non-functional status will be
removed when another check or alarm call arrives in the server from this intercom. The
default value of this parameter is 72 hours. The Alarm call response specifies the type
of alarm call processing:
, an Normal call Confirm with 1, CPC Antenna, CPC KONE
d Similarly, the Check call response specifies the type of check call processing: P100.
, , , and Reject Accept and send 5 Confirm with 1 and 5 CPC Antenna, CPC KONE
. Complete the serial number of your intercom in the Serial number field. P100
Together with Password, this parameter is relevant for a correct function of the data
tunnel. The default password is 2n. Click Save to confirm the setting. If you select the
type, set the outgoing check call parameters too: select Active check calls 2N Helios
®
to enable active check calls for the selected intercom, complete First run to define the
first check call and Next run to define the next check call to the intercom. Complete the
Unsuccessful call repeat count to specify how many check call attempts are to be made
before the system detects an error and executes the action set in the Call server.