2N Lift8 v1.6.0 User Manual
Page 85
Advertising
85
Figure: Cabin Audio Unit – Universal Mounting Hole Dimensions
To mount the unit, you need 4 electrically spot-welded (from the inner panel side)
M3
or
screws, a sufficiently perforated speaker area and a microphone hole. If needed,
M4
a high-quality double-sided foam self-adhesive tape can be used for installation on a
perfectly degreased surface.
Warning
Leave no gap between the lift control panel and the audio unit surface to
avoid acoustic speaker fault and acoustic speaker-microphone feedback.
this type of audio unit
Do not use
otherwise than mounted on a
sufficiently large board. The acoustic properties of an uninstalled audio
unit cannot be guaranteed.
Advertising