4 hand probe p50, 1 general information, 2 description – INFICON Sensistor ILS500 Leak Detection System User Manual
Page 19: 3 calibration, Hand probe p50, General information, Description, Calibration, 4hand probe p50, 1 general information 4.2 description
Hand Probe P50
19
ninb63e1-f (1410)
4
Hand Probe P50
4.1
General Information
4.2
Description
Hand Probe P50 (Rigid Neck)
The Hand Probe P50 is a non-sniffing probe. Gas analysis takes place in the
replaceable sensor located in the tip of the probe.
For more information about the Hand Probe P50, refer to the Operating Manual and
Technical Reference Manual for Sensistor ISH2000.
4.3
Calibration
The probe needs to be calibrated for optimal accuracy. Make sure it is calibrated when
it is used for the first time. For more information about calibration, see on page 58.
Caution
Do not expose the probe to a hydrogen concentration greater than 0.1% when the
instrument is not operating, as this could damage or destroy the probe sensor.
Caution
Connection and disconnection of the sensor cable must be done with power OFF.
Sensor can be damaged if power is on.
1
Hydrogen Sensor
2
Indicator LED lamps
3
Function Button
4
Lamps
3
4
2
1
Notice
The probe can be ordered with a flexible neck. For more information, see
on page 99.