INFICON Sensistor ILS500 Leak Detection System - Manual (Page 35)

Menu System 35
ninb63e1-f (1410)
7.3 Menu Overview
For information about parameter factory default settings, see on page 104.
Notice The instrument is equipped with a Leak Detector ISH2000, which means
that some settings are blocked. These settings are accessed using the
ILS500 operator panel.
Calibration
Load Recipe
Settings Hardware Setup
Test Settings Tooling Connection
Pre Evacuation
Gross Leak Test Vacuum Decay Test
Pressure Decay Test
Tracer Gas Filling
Blockage Test
Tracer Gas Test
Gas Evacuation
Tooling
Disconnection
Advanced Settings Timers
Pressures
Options
ISH2000
Service Menu Outputs
Inputs
Analog Inputs
System Reset
ILS500
RS232
Service Run
Hardware Test
Passwords
IP-Settings
Calibration Settings
Recipes
Statistics