INFICON Sensistor ILS500 Leak Detection System - Manual (Page 8)

8
ninb63e1-f (1410)
Safety ILS500
INFICON can not take any responsibility for the consequences arising from
inappropriate use of certain test pressures.
Warning
The ILS500 must never be introduced to pressures higher than that approved for the
object to be tested and never beyond the ILS500 specification.
Warning
Be sure to have a pressure relief valve in case of accidental tracer gas pressure
increase.
Warning
When dealing with high pressures, a blast protection is needed between the Test
Port and the Test Object.
Warning
When dealing with test objects that cannot stand high pressure increase, make sure
to mount a flow control valve on the Test Ports.
Warning
Make sure not to confound Compressed Air and Tracer Gas.
Notice The ILS500 has no internal emergency stop circuit. ILS500 is prepared for
integration into an external emergency stop circuit.
Check that all relevant legislation and safety standards are complied with
before putting the ILS500 into service. See further information under
Installation.