INFICON Sensistor ILS500 Leak Detection System - Manual (Page 30)

30 Setup
ninb63e1-f (1410)
6.3.4 Connecting to Test Port 1 and 2
• Use both Test Ports if applicable.
• Hose ID ≥ 8 mm (0.31 in.).
• The hoses should be as short as possible.
6.3.5 Connecting Tooling
Tooling Valve Outputs 1-4 is available for connection of external Tooling.
If the test object has 2 or more ports, connect to ports on opposite sides of object.
Notice The larger the test object, the more important to follow the
recommendations above.
Warning
Be aware that the faster the connection is made, the higher the risk for injury. Be
careful and install guards etc, according to local legislation and safety standards so
that your fixture is safe to use.