INFICON CMS5000 Monitoring System - Manual (Page 212)

15 - 6
IP
N 07
4-
50
8-
P1
C
CMS5000 Operating Manual
15.4.1 CMS5000 Temperatures (C)
These temperatures are the setpoints that the following components must reach
before data acquisition can begin.
Column . . . . . . . . . . . . . . . . . . . The initial Column temperature for the
method.
Valve Oven Htr . . . . . . . . . . . . . The target value Oven Heater temperature.
Ck Std Heater . . . . . . . . . . . . . . The target Check Standard Heater
temperature.
AI Detector Heater . . . . . . . . . . The target temperature the Micro Argon
Ionization Detector (MAID).
Regulator. . . . . . . . . . . . . . . . . . The target temperature of the Regulator,
which controls the head pressure.
15.4.2 Method Type Selection
Water . . . . . . . . . . . . . . . . . . . . . Sets the method parameter for water
sampling.
Air . . . . . . . . . . . . . . . . . . . . . . . Sets the method parameter for air sampling.
Ck Std . . . . . . . . . . . . . . . . . . . . Sets the method parameter for the Check
Standard (Toluene) method.
NOTE: In the following sections, the Method Type is set to Water.
15.5 Inlet
The Inlet page displays the default settings for the Inlet States, GC Temperature
Profiles and Valve States. Adjusting settings on the Inlet page may affect other
method parameters and/or the retention time. The Start time of each Inlet State
event is displayed in combination with the temperature profile at the bottom of the
Inlet page. See
Figure 15-9 .