5 water monitoring assembly instructions – INFICON CMS5000 Monitoring System User Manual
Page 25
3 - 5
IP
N 07
4-
50
8-
P1
C
CMS5000 Operating Manual
3.5 Water Monitoring Assembly Instructions
If not using the CMS5000 for water monitoring, skip to
The temperature sensor, or RTD, will be unfastened and taped to the bottom of the
CMS5000 for shipment. Remove the tape, guide the excess wire back into the
CMS5000, and screw the stainless steel nut into the port nearest to the beige
sample collection tube mounting bracket located on the bottom of the CMS5000.
The Swagelok® fitting should be tightened 1/4 turn past finger tight using a 7/16”
open end wrench. See
Figure 3-3 Attaching the Temperature Sensor
The PEEK purge tube (found in the ship kit) is attached to the middle port in the
beige sample collection tube mounting bracket. See
Figure 3-4
.
Figure 3-4 Attaching the PEEK Purge Tube