6 attaching the water sampling vessel – INFICON CMS5000 Monitoring System User Manual
Page 27
3 - 7
IP
N 07
4-
50
8-
P1
C
CMS5000 Operating Manual
3.6 Attaching the Water Sampling Vessel
NOTE: If you are not using the CMS5000 for water monitoring, skip sections
The optional sampling vessel mounts to the bottom of the CMS5000 using the wing
nuts supplied in the sampling source kit. See
Figure 3-7
.
Figure 3-7 Optional Sampling Vessel
Attach the sampling vessel to the CMS5000 by aligning the screws with the four
openings on the flange of the sampling vessel. Hold the vessel against the
mounting screw standoffs and screw on the wing nuts to hold the sampling vessel
in place. See
Figure 3-8
.
Figure 3-8 Attaching the Sampling Vessel
The function of the standoffs is to provide spacing between the CMS5000 and the
vessel to allow water overflow to prevent water from entering the analytical module.
See
Figure 3-9
.