INFICON SQC-310 Thin Film Deposition Controller - Manual (Page 51)

Chapter 3 Menus
3-13
On the Cut/Paste menu, highlight a layer and press Cut to remove the layer. The cut
layer is removed from the process and placed on the clipboard. Highlight a layer and
press Copy to place a copy on the clipboard without removing the layer.
The display changes to the Insert Layer Menu. The Paste Normal and Paste Codep
SoftKey may not be visible if the operation is not legal for the selected layer.
Insert Layer Menu
To
Main
Prev
Menu
Process 1 -> Layer 1 -> Film 1
Layer
Film1
Film
Layer 1.1
Paste
Normal
Paste
CoDep
Layer 1.2 Film2
Layer 1.3 Film3
Layer 2.1 Film5
Remember that layers are always pasted at the highlighted layer. That is, the pasted
layer will have the same number as the highlighted layer, and the highlighted layer will
move down one layer.
Hint: When building a process it is easiest to add a “dummy” last layer and keep
inserting above that layer. When the process is complete, delete the “dummy” layer.
For example, to insert a new Layer 1, highlight Layer 1 and press Paste Normal. The
layer is as Layer 1. The existing Layer 1 becomes Layer 2. Layer 2 becomes Layer 3,
etc.
To insert a Codep layer with Layers 1-3, highlight Layer 4 and press Insert Codep. The
new layer will be inserted as a Codep Layer 4 (indented and below Layer 3). The
existing Layer 4 becomes Layer 5.
Note: Each Codep layer must be assigned to a different output and sensor. A warning
message is displayed if there is a conflict. Highlight each Codep layer, press Edit, and
assign unique sensors and outputs.