INFICON SQC-310 Thin Film Deposition Controller - Manual (Page 9)

Chapter 1 Quick Start
1-3
1.2 Rear Panel
1 0 0 - 1 2 0 /2 0 0 -2 4 0 V ~
5 0 /6 0 H z
2 5 V A
S e n s o r 1 S e n s o r 2 O u tp u t 1 O u tp u t 2 I/O 1 -8
R S -2 3 2
S e n s o r 3 S e n s o r 4 O u tp u t 3 O u tp u t 4
in s tru m e n ts
S ig m a
M a n u fa c tu re d B y 
I/O 9 -1 6
F u s e T .5 A 2 5 0 V
S Q C -3 0 0 D e p o s itio n C o n tro lle r
S e ria l N o .
U S B /E th e rn e t
Rear Panel Connections
Sensor 1 & 2 Connects to quartz crystal sensor (see next section).
Output 1 & 2 Connects the SQC-300 output to your evaporation supply
control input (see next section).
I/O (1-8) Connects 8 relays and 8 digital inputs to external equipment for
process control. See Appendix C for wiring.
RS-232
USB or Ethernet Connects to a computer for programming and data acquisition.
RS-232 and USB are standard. Ethernet option replaces USB.
Sensor 3 & 4,
Output 3 & 4,
I/O 9-16 Increases the number of input, output, and digital I/O
connections when the optional expansion card is installed.
Measurement ground terminal useful for common system and
cable grounding.
Power Input and
Fuse Connects to mains power. The SQC-300 automatically detects
mains voltages of 100-120 and 200-240VAC, 50/60 Hz
W ARNING : For continued protection, replace fuses with the
proper type and rating. Use power cords only of the specified
type and rating, attached to a properly grounded receptacle.