Bench checkout & inspection, Inspection, Initial power up – INFICON MDC-360C Thin Film Deposition Controller User Manual

Page 33: Sample program, Bench checkout & inspection -1, Inspection -1, Initial, Power, Up -1, Sample

Advertising
background image

MDC-360C DEPOSITION CONTROLLER

BENCH CHECKOUT & INSPECTION

3-1

3.

BENCH CHECKOUT & INSPECTION

3.1 INSPECTION

Your MDC-360C was released to the carrier in good condition and properly
packed. It is essential to all concerned that the contents of the shipment be
carefully examined when unpacked to assure that no damage occurred in transit.
Check the material received against the packing list to be certain that all elements
are accounted for. Items included with your controller are:

1 MDC-360C Deposition Controller
1 Operation and Service Manual
1 Power cord
1 Source cable (4 pin mini DIN connector)
1 Discrete I/O connector kit (37P D shell)


In addition, you may have ordered one or more of the accessories listed in Section
1.4. If there is evidence of loss or damage:

a) Notify the carrier or the carrier agent to request inspection of the loss

or damage claimed.

b) Keep the shipping containers until it is determined whether or not they

are needed to return the equipment to INFICON.

3.2

INITIAL POWER UP

Upon initial power up the unit will start with all LED’s lighted. The
Parameter/Status display will show the controller Sign-on screen with its
configuration information. See Figure 5-1. The unit will stay in this state until a
key is pressed.

When any key on the front panel is pressed, the operating display and the
Parameter/Status display will return to the last viewed screen prior to loss of
power.

3.3 SAMPLE

PROGRAM

The sample program listed below is included in the MDC-360C memory at the
time of shipment. It can be used to check out the controller by running it in
Simulate mode. Follow instructions in Section 4 to navigate through the menu
structure. Check the controller parameter values against the sample program for
discrepancy and change if necessary. Note also, if the source or sensor
configuration has been changed during familiarization with the controller
programming, appropriate source and sensor parameter values also need to be
retained for the sample program to run correctly.

Once the sample program has been checked, use the programming Main Menu,
Edit System Setup, Edit Utility Setup, to select Simulate mode ON, then use Start
to select and run the sample program in Simulate mode.

Advertising