Leica Biosystems CM1950 - Manual (Page 11)

11 Leica CM1950 – Cryostat
2. Safety and Design
• Lift and remove the wooden edge (7, Fig. 5 ).
• Remove the ramp (6, Fig. 4 ) from the pallet.
• Properly insert the ramp. Make sure that the
ramp components designated "L" (left) and
"R" (right) click into place in the intended
guide channel (10, Fig. 6a ). When correctly
assembled, the guide rails (11) are located
inside, while the arrows (12) point toward
each other.
7


Fig. 5
Fig. 6
6 6
• Carefully roll the instrument backwards over the ramp from the pallet.
• Push the instrument to the installation location on the castors (8,
Fig. 6 ).
8
9
10, Transport
grip points
Do not push the device by its hood (9, Fig. 6 )!
Instead, use transport grip points (10 , Fig. 6 )!
The front and rear rollers must stay on the ramp (6). Danger of tipping!
12
11
10
Fig. 6