Lenze E82EV 8200 - Manual (Page 151)

Commissioning
Important codes for quick commissioning
7
l
151 EDK82EV113 DE/EN/FR 11.0
IMPORTANT Possible settings Code
Selection Lenze Name No.
C0007
v
uSEr
(Cont.)
E4 E3 E2 E1
41 JOG1/3 DCB TRIP−Set DFIN1−ON
42 QSP DCB TRIP−Set DFIN1−ON
43 CW/CCW QSP TRIP−Set DFIN1−ON
44 UP DOWN PAR DFIN1−ON
45 CW/CCW QSP PAR DFIN1−ON
46 H/Re PAR QSP JOG1/3
47 CW/QSP CCW/QSP H/Re JOG1/3
48 PCTRL1−
OFF
DCB PCTRL1−I−
OFF
DFIN1−ON
49 PCTRL1−
OFF
JOG1/3 QSP DFIN1−ON
50 PCTRL1−
OFF
JOG1/3 PCTRL1−I−
OFF
DFIN1−ON
51 DCB PAR PCTRL1−I−
OFF
DFIN1−ON
255 Free configuration in C0410 Read only
Do not change C0007 since settings
in C0410 may get lost
C0010
uSEr
Minimum
output
frequency 0.00 0.00
à 14.5 Hz {0.02 Hz} 650.00 l C0010 not effective in the case of
bipolar setpoint selection (−10 V ...
+ 10 V)
l C0010 only limits the analog
input 1
l In the case of a max. output
frequency > 50 Hz the switching
threshold of the auto DCB in
C0019 has to be increased.
l From software 3.5: If
C0010 > C0011, the drive does
not start when controller enable
is set.
à Speed setting range 1 : 6 for Lenze
geared motors: For operation
with Lenze geared motors has to
be set necessarily.
C0011
uSEr
Maximum
output
frequency 50.00 7.50
à 87 Hz {0.02 Hz} 650.00
C0012
uSEr
Acceleration
time main
setpoint 5.00 0.00 {0.02 s} 1300.00 Reference: frequency change 0 Hz ...
C0011
l Additional setpoint ðC0220
l Acceleration times that can be
activated via digital signals
ð
C0101
C0013
uSEr
Deceleration
time main
setpoint 5.00 0.00 {0.02 s} 1300.00 Reference: frequency change C0011...
0 Hz
l Additional setpoint ðC0221
l Deceleration times that can be
activated via digital signals
ð
C0103