Rockwell Automation 1756-OF8I ControlLogix Eight-channel Isolated Analog I/O Modules - Manual (Page 122)

122 Rockwell Automation Publication 1756-UM540A-EN-P - May 2014
Chapter 7 Configure ControlLogix Isolated Analog I/O Modules
Create a New Module After you create a Logix Designer application project, complete the following
steps to create a new module in the project.
1. Right-click I/O Configuration and choose New Module.
2. Select the module and click Create.
3. Click OK to accept the default major revision.
The New Module dialog box appears.
TIP You can verify the module’s revision in RSLinx® Classic software.