Rockwell Automation 2707-L40X_L8X_V40X DTAM Plus Operator Interface Module Installation Instructions - Manual (Page 105)

Chapter 7
Troubleshooting and Maintenance
7–17
To clean the display window:
!
ATTENTION: Use of abrasive cleansers or solvents may
damage the window. Do not scrub or use brushes. Some types of
paper towels may scratch the window, only use a soft sponge or
cloth.
1. Disconnect power from the DTAM Plus at the power source.
2. Using a clean sponge or a soft cloth, clean the display with a mild soap
or detergent.
3. Dry the display with a chamois or moist cellulose sponge to avoid
water spots.
Removing Paint and Grease
Remove fresh paint splashes and grease before drying by rubbing lightly
with isopropyl alcohol. Afterward, provide a final wash using a mild soap or
detergent solution. Rinse with clean water.
Cleaning the Display Window