Rockwell Automation 2707-L40X_L8X_V40X DTAM Plus Operator Interface Module Installation Instructions - Manual (Page 47)

Chapter 3
Using the Function Menu
3–5
The R–Port option allows you to display (not modify) Remote I/O
parameters for the DTAM Plus. These parameters are set from the
programming software when an application is downloaded.
The R–Port option is only available for versions with a Remote I/O port.
To display Remote I/O communication parameters:
1. Select Special [5] from the Function Menu.
1 C-Port 5 Special
2 P-Port 6 Term
3 Clk/Cal 7 Test
4 Reset 8 Other
This menu displays:
1. P - AD
2. R - PORT
Note: P–AD functions are described in Appendix C
2. Select R–Port [2] from the menu.
This menu displays:
1 BaudRate 4 RackNum
2 RackSize 5 ModuGrp
3 LastRack 6 Reset
Select an item by pressing the corresponding numeric key [1]
! [6].
The current setting for the selected parameter is displayed. Press [ ] to
return to the previous menu.
Baud Rate
Selecting BaudRate [1] displays the current baud rate.
Baud Rate 230.4K
”ENTER” To Continue
Rack Size
Selecting RackSize [2] displays the current rack size.
Rack Size FULL
”ENTER” To Continue
Displaying Remote I/O
Port Parameters