Comm port test – Rockwell Automation 2707-L40X_L8X_V40X DTAM Plus Operator Interface Module Installation Instructions User Manual
Page 97
Chapter 7
Troubleshooting and Maintenance
7–9
Use the communications test to verify the operation of the RS-232/
RS-485 Comm port.
The communications test requires a loopback connector. You can construct a
simple loopback connector as follows:
1
Data Out –
2
Data Out +
3
Data In -
4
Data In +
5
Signal Ground
6
Transmit Enable
7
Not Used
8
Signal Ground
9
Shield
Pin# Signal Name
9 Pin Female
1
Not Used
2
Receive Data (RD)
3
Transmit Data (TD)
4
Not Used
5
Signal Ground
6
Not Used
7
Not Used
8
Not Used
9
Shield
Pin# Signal Name
Connects pins 2
!3
Loopback Connector
RS-232 Port
RS-485 Port
Connects pins 1
!3
and pins 2
! 4
Loopback Connector
9 Pin Female
To test the Comm port:
1. Use the [NEXT] or [PREV] keys to display Comm on the
test selection screen.
2. Press [
] to initiate the test.
The DTAM Plus will continuously send out and receive a message at the
same port. The message is DTAM Plus self looping serial test
ABCDEFGHIJKLMNOPQRSTUVWXYZ0123456789.
DTAM Plus self loop
ing serial test ABCD
3. Press any key to terminate the Comm Port test.
The next test selection screen is displayed.
DTAM Plus Diagnostic
NEXT to Select Test
ENTER To Initiate
Printer Port
4. To terminate the test function , press the [NEXT] or [PREV] keys to
display Reset DUT in the test selection area. Press [
] to reset the
DTAM Plus.
Comm Port Test