Rockwell Automation 2707-L40X_L8X_V40X DTAM Plus Operator Interface Module Installation Instructions - Manual (Page 58)

Chapter 3
Using the Function Menu
3–16
The Special [5] menu item on the function menu may be password protected
to restrict access to the P-A/D feature. When an application has a security
screen, the operator will be prompted for a security code. The master
security code provides access to the Special menu and all other security
codes allowing them to be modified. Two master security codes perform
special functions:
00000000 allows the operator to modify the existing master code without
entering the current code.
99999999 does not allow operator to modify security codes. The master
security code must be changed using the DPS software.
Note: DIP Switch SW-3 must be ON to access the master code function.
To enter a new Master Security code:
1. From the Function Menu, select Other [8].
1 C-Port 5 Special
2 P-Port 6 Term
3 Clk/Cal 7 Test
4 Reset 8 Other
The Other Menu appears:
1 Simulate 5 Mastr C
2 BL / Int 6 Scale E
3 Contrast 7 Exit
4 Prn Scrn
2. Press [5] to select the Master security code function.
The master code entry screen displays:
Enter Current Master
Code:_
3. Enter the current code and press [ ].
You are prompted to enter a new code.
Enter New Master
Code:_
4. Enter a new code.
Entering a New Master
Security Code