Rockwell Automation 2707-L40X_L8X_V40X DTAM Plus Operator Interface Module Installation Instructions - Manual (Page 34)

Loading an Application
Chapter 2
2–8
This section shows how to download an application from a computer running
DPS software to the DTAM Plus. Refer to the DPS Programming Manual
(Publication No. 2707-801) for additional information.
To download an application:
1. Apply power to the DTAM Plus.
The following message appears.
Programming Mode
Waiting Up/Download
If you do not see this message, check the DIP switch settings.
DIP Switch SW-1 must be ON.
2. On your computer, move to the /DPS subdirectory.
C:\DPS>
3. Type dps and press [Return] to start the program.
C:\DPS>dps [Return]
4. Specify whether you are using a color monitor. Enter Y or N.
5. The startup screen displays:
Voice: 440–646–6800
FAX: 440–646–6850 or 6890
E–mail: [email protected] Technical Support
. You will not see this prompt if
a monitor was specified during
DPS installation.
Downloading an Application