Rockwell Automation 2707-L40X_L8X_V40X DTAM Plus Operator Interface Module Installation Instructions - Manual (Page 70)

Chapter 5
Installation
5–2
!
ATTENTION:
EXPLOSION HAZARD: SUBSTITUTION OF
COMPONENTS MAY IMPAIR SUITABILITY FOR CLASS
1, DIVISION 2.
RISQUE D’EXPLOSION: LA SUBSTITUTION DE
COMPOSANTS PEUT RENDRE CE MATÉRIEL
INACCEPTABLE POUR LES EMPLACEMENTS DE
CLASSE 1, DIVISION 2.
!
ATTENTION: USE P1 POWERED UNITS ONLY WITH
CLASS 2 POWER SOURCE LIMITED TO 30 VDC OPEN
CIRCUIT AND 8A SHORT CIRCUIT.
ATTENTION: UTILISER AVEC UNE TENSION
D’ALIMENTATION CLASSE 2 DE 30 VCC MAXI EN
CIRCUIT OUVERT AVEC UN COURANT DE
COURT-CIRCUIT DE 8A MAXI.
!
ATTENTION:
EXPLOSION HAZARD: DO NOT CONNECT OR
DISCONNECT EQUIPMENT WHILE CIRCUIT IS LIVE
UNLESS AREA IS KNOWN TO BE NON-HAZARDOUS.
RISQUE D’EXPLOSION: NE PAS BRANCHER OU
DEBRANCHER TANT QUE LE CIRCUIT EST SOUS
TENSION, A MOINS QU’IL NE S’AGISSE D’UN
EMPLACEMENT NON DANGEREUX.
Refer to the inside front cover of this manual for additional guidelines.
The DTAM Plus is rated for an operating temperature range of:
•
LCD displays – 32
_F to 113_F (0_C to 45_C)
•
VFD displays – 32
_F to 140_F (0_C to 60_C)
The storage temperature range is -4
°
F to 185
°
F (-20
°
C to 85
°
C).
The humidity rating is 5% to 95% relative humidity (noncondensing).
Operating Environment