Rockwell Automation 2707-L40X_L8X_V40X DTAM Plus Operator Interface Module Installation Instructions - Manual (Page 61)

Chapter 3
Using the Function Menu
3–19
The Point - Access / Display function allows you to display and modify
controller data files. The P-A/D function does not allow you to write
controller Input and Output files.
Appendix C provides a listing of the applicable file types for SLC and
PLC-5 controllers, along with step-by-step instructions on how to use the
P-A/D function.
To access the Point - Access/Display Function:
1. From the Function Menu, select Special [5].
1 C-Port 5 Special
2 P-Port 6 Term
3 Clk/Cal 7 Test
4 Reset 8 Other
This menu displays:
SLC 50X Network Addr
Press
”Y’ to Edit Address
”N” to Bypass
1. P – A/D
2. R – PORT
Remote I/O
Operating System
PLC5 DF1
Operating System
DH485
Operating System
DTAMPlus:00 Max:02
SLC Expected At 01
Input NewSLC Node01*
Press ENTER
1. P – A/D
2. SLC 50X Mode
3. Memory Transfer
4. Clear SLC Fault
1. P – A/D
2. PLC Mode
3. Memory Transfer
4. Clear PLC Fault
* Only applies to the P-A/D function.
2. Select the P-A/D [1] option.
3. See Appendix C for details on how to use the P-A/D function.
Note: When an application is created (using DPS programming software), a
special security screen can be configured that restricts access to the Special
Menu.
Accessing the Point/Access
Display Function