Rockwell Automation 2707-L40X_L8X_V40X DTAM Plus Operator Interface Module Installation Instructions - Manual (Page 15)

Chapter 1
DTAM Plus Overview
1–3
Figure 1.2
DTAM Plus (back view)
DIP Switch
(Behind Removable
Cover)
Power Connector
Fuses
Communication Ports
Communications Port
The DTAM Plus is available with a variety of communication options as
shown below.
Port Type
Catalog No.
RS-232/485 Printer Remote I/O
2707-L8P1, -L8P2 X
2707-L40P1,-L40P2, -V40P1,-V40P2,-V40P2N X X
2707-L8P1R, -L8P2R, X
➀
X
2707-L40P1R, -L40P2R, -V40P1R, -V40P2R,
-V40P2NR
X
➁
X
➀ For transferring applications only; no host communications.
➁ Also use to transfer applications or upgrade firmware.
Power Connector
The power connector is a non-removable, screw terminal block. Refer to the
power connector label (on back of DTAM Plus) for the proper voltage range.
DIP Switch
A 6-position DIP switch (under a removable cover) on the back selects
operating settings. To remove cover, align cover tabs with notches in hole.