Rockwell Automation 2707-L40X_L8X_V40X DTAM Plus Operator Interface Module Installation Instructions - Manual (Page 57)

Chapter 3
Using the Function Menu
3–15
Line Feed Enable
Selecting L/Feed [2] enables/disables Line Feed. When enabled, The DTAM
Plus sends a line feed (LF) and carriage return (CR) each time a carriage
return is received. When disabled, only a carriage return is sent.
L/Feed Enable OFF (0)
”1” or ”Y” = ON
”0” or ”N” = OFF
ENTER = NC
Press [1] or [Y] to enable a line feed. Press [0] or [N] to disable a line feed.
Press [
] to return to P-Port menu without any change.
Cursor Enable
Selecting Cursor Enable [3] enables/disables a block cursor display. When
enabled, The DTAM Plus uses a block cursor display.
Cursor Enable ON (1)
”1” or ”Y” = ON
”0” or ”N” = OFF
ENTER = NC
Press [1] or [Y] to enable a block cursor display. Press [0] or [N] to disable a
the block cursor. Press [
] to return to P-Port menu without any change.