Rockwell Automation 2707-L40X_L8X_V40X DTAM Plus Operator Interface Module Installation Instructions - Manual (Page 115)

Appendix B
DTAM Plus Cable Diagrams
B–5
Catalog No. 1747-CP3
Use this RS-232 Communications Cable to connect the RS-232 Comm port
of the DTAM Plus to Channel 0 of an SLC 5/03, 5/04. A 9 pin male to
female gender adapter is required when using this cable. If you are making
your own cable, use a 9 pin male connector on the DTAM Plus end instead of
the 9 pin female connector (with 90
_ bend allowing closure of the SLC door)
shown below. In addition, the control lines are not needed.
DTAM Plus RS-232
Comm Port
CD
RXD
TXD
DTR
1
2
3
4
5
9-Pin Female D Connector
6
7
8
9
COMMON
DSR
RTS
CTS
RI
CD
RXD
TXD
DTR
1
2
3
4
5
6
7
8
9
COMMON
DSR
CTS
RTS
RI
9-Pin Female D Connector
SLC 5/03 Channel 0 Port
RS-232
Note: A gender adapter is required when
using the 1747-CP3 cable. If you are
creating your own cable, use a male
connector on the DTAM Plus end.
= Not used for DTAM Plus
The control lines (pins #1, #4, #6, #7, and #8) are not used by the DTAM
Plus. The connections to these pins can be deleted for this application.