Rockwell Automation 2707-L40X_L8X_V40X DTAM Plus Operator Interface Module Installation Instructions - Manual (Page 23)

Chapter 1
DTAM Plus Overview
1–11
The DTAM Plus is preset at the factory with the following defaults:
Operating System
The DTAM Plus is provided with a default DH-485 application file.
The application file displays a screen with the message:
Bul 2707 DTAM Plus
No Program Loaded
DIP Switch Settings
The DTAM Plus is shipped with the following DIP Switch settings:
DIP Switch
Position
Default
Setting
Function
1 ON Upload/Download Enabled
2 ON Communication Port Selection (RS-485)
3 ON Master Security Enabled
4 OFF Function Key Disabled
5 OFF Terminal Mode Disabled
6 ON COMM Upload/Download Enabled
Default Settings