Rockwell Automation 2707-L40X_L8X_V40X DTAM Plus Operator Interface Module Installation Instructions - Manual (Page 38)

Loading an Application
Chapter 2
2–12
14. When the download is complete, you return to the Opening Menu.
and the DTAM Plus displays:
Programming Mode
Waiting Up/Download
15. Press [Esc] to exit the software.
16. Press [Y] to return to DOS.
The application is now loaded in the DTAM Plus. You can test the
application using the simulate function described in Chapter 4 or you can
run the application as described in Chapter 5.
Important: To run the application, set DIP switch SW-1 OFF. The
DTAM Plus will reset and start the application.