Rockwell Automation 2707-L40X_L8X_V40X DTAM Plus Operator Interface Module Installation Instructions - Manual (Page 50)

Chapter 3
Using the Function Menu
3–8
Parity
Selecting Parity [3] displays the current setting.
Select Parity:
Parity
None
”NEXT” To Change
”ENTER” To Select
Press [NEXT] to change between Even, Odd, or No parity. Press [ ] to
select a new parity.
Handshake
Selecting Hndshk [4] enables/disables handshaking. Handshaking is a
request to send a communications signal (RTS) and notification that a
transmission may be sent (CTS).
HNDSHK Enable OFF (0)
”1” or ”Y” = ON
”0” or ”N” = OFF
ENTER = NC
Press [1] or [Y] to enable handshaking. Press [0] or [N] to disable
handshaking. Press [
] to return to P-Port menu without any change.
Line Feed
Selecting L/Feed [5] enables/disables Line Feed. When enabled, The DTAM
Plus sends a line feed (LF), in addition to a carriage return after a form has
been printed. When disabled, only a carriage return is sent.
L/Feed Enable OFF (0)
”1” or ”Y” = ON
”0” or ”N” = OFF
ENTER = NC
Press [1] or [Y] to enable a line feed. Press [0] or [N] to disable a line feed.
Press [Enter] to return to P-Port menu without any change.
Port Enable
Selecting PEnable [6] enables/disables the printer port. You must enable the
printer port, to upload or download applications through the port.
PEnable ON (1)
”1” or ”Y” = ON
”0” or ”N” = OFF
ENTER = NC
Press [1] or [Y] to enable the printer port. Press [0] or [N] to disable the
printer port. Press [
] to return to P-Port menu without any change.