Rockwell Automation 2707-L40X_L8X_V40X DTAM Plus Operator Interface Module Installation Instructions - Manual (Page 69)

A–B
5
Chapter
5–1
Installation
This chapter contains the following sections:
Section Page
Safety Guidelines 5–1
Operating Environment 5–2
Enclosures 5–3
Equipment Required 5–3
Clearances 5–3
Mounting Dimensions 5–4
Cutout Template 5–5
Installation 5–6
Connecting Power 5–7
Install the DTAM Plus using publication NFPA 70E, Electrical Safety
Requirements for Employee Workplaces as a guide.
In addition, grounding is an important safety measure in electrical
installations. A source for grounding recommendations is the National
Electrical Code published by the National Fire protection Association of
Boston Massachusetts.
Be certain to follow all directions for installing and connecting power to the
DTAM Plus.
When used in a hazardous environment, the ultimate enclosure must be in
accordance with Class 1, Division 2 wiring methods as described in the
National Electrical Code (ANSI/NFPA 70) and the Canadian Electrical Code.
All peripheral equipment must be suitable for the location in which it is used.
For P1 powered units, use only a Class 2 power source as described in the
National Electrical Code (ANSI/NFPA 70) and the Canadian Electrical Code.
Objectives
Safety Guidelines