Rockwell Automation 5370 Color CVIM Communications Manual - Manual (Page 109)

Chapter 5
Using the RS–232 Ports
5–41
Use the load command to transfer configuration data between the Color
CVIM module local storage area (EEPROM) and the external memory card.
The RAM card slides into the slot on the front of the Color CVIM module.
Use one of the following commands:
Transfers configuration from the EEPROM to the Color CVIM module
internal RAM.
Transfers memory from RAM Card area 1 to the Color CVIM module
internal RAM.
Transfers memory from RAM Card area 2 to the Color CVIM module
internal RAM.
Note: Memory cards are laid out in slots. A 64K card (2801–MD4) has
room for two configurations. The 512K memory card (2801–MD5) has 16
slots, and can store up to 16 configurations. An image must be one of the
first two items stored to the 512K card, and can only occupy 12 contiguous
free slots.
You cannot use these commands when the Color CVIM module is in the
SETUP mode.
If the BCC is not valid, the Color CVIM module will respond with a DLE
NAK and the command will not be executed.
If the BCC is valid, the Color CVIM module will respond with a DLE ACK.
Then the Color CVIM module will validate the command structure. If the
command is valid, the Color CVIM module will execute the command. If the
command structure is invalid, the Color CVIM module will not execute the
command or respond.
Loading Configurations