Rockwell Automation 5370 Color CVIM Communications Manual - Manual (Page 176)

(Host Input & Output Bits)
Appendix B
Discrete Bit Results Bits
B–22
Table B.3
Discrete Bit Outputs (Cont’d)
PI Backplane Remote I/O
Word # Bit # Word # Bit #
Definition Usage Notes
4 8–11 2 10–13
Configuration Move
Control
0000 = No
0001 = EEPROM to RAM
0010 = RAM to Request
EEPROM
0100 = RAM Card to RAM
1000 = RAM to RAM Card
4 12–15 2 14–17 RAM Card Index
0000 = RAM Card
11111 = RAM Card
Configuration
Configuration 16
Numeric fields which specify RAM card
locations 1 through 16.
5
Reference
Only. Not
used for
Backplane.
N/A 3 0–2 Block Transfer Type
000 = Invalid Request
001 = Results Block
010 = Configuration Block
101 = Statistics Block –
See Notes
111 = Programmable Block
Transfer – See Notes.
This word only applies to Remote I/O
interface.
To send the programmable block transfer
to the Color CVIM, set bits 0, 1, and 2 to
equal 111 and then send a block transfer
write. No other bits (last block, toolset, or
block number) need to be sent.
After sending a configuration block or
template block to the Color CVIM, you
should check the condition of the
configuration fault bit (Word 0, Discrete
Bit inputs).
To send programmable statistics, set bits
0, 1, and 2 to equal 101 and then send a
block transfer write to the Color CVIM.
No other bits (last block, toolset, or block
number) need to be sent.
5
Reference
Only. Not
used for
Backplane.
N/A 3 3 Last Block Flag
0 = Not Last Block
1 = Last Block
Applies only to block transfer writes.
5
Reference
Only. Not
used for
Backplane.
N/A 3 4–7 Toolset Request 0001 = Toolset Active
Applies only to results blocks. Must be
0001 for all Block Transfers.
5
Reference
Only. Not
used for
Backplane.
N/A 3
10–
17
Block Transfer
Block Number
0 = Invalid Number
See Notes.
Results block numbers may be from 1 to
4.
Configuration block numbers may be
from 1 to 136.
Template block numbers may be from 1
to 255 (variable).