Read inspection results – Rockwell Automation 5370 Color CVIM Communications Manual User Manual
Page 84
Chapter 5
Using the RS–232 Ports
5–16
Use this command to read the results of the last inspection. Refer to
Appendix B for a description of the results blocks. Use the following
commands:
>RRx,o,d [CR]
Where:
x
=
Number of times command is
repeated.
o
=
RL (specifies Reference Line)
RW (specifies Reference Window)
G (specifies Gage)
W (specifies Window)
LP (specifies Light Probe)
d
=
Gage, Window, Reference Line, or
Reference Window number.
>RR [CR]
Reads all discrete bit results.
>RRx,P1 [CR]
Reads discrete bit first part results.
x = Number of times command is repeated.
>RRx,P2 [CR]
Reads discrete bit second part results.
x = Number of times command is repeated.
>RRx,RB,d [CR]
Reads results block(s).
x = Number of times command is repeated.
d = Block number.
>RRx, S [CR]
Reads Color CVIM module status.
Read Inspection Results