Rockwell Automation 5370 Color CVIM Communications Manual - Manual (Page 53)

Chapter 4
Using the Remote I/O Link
4–16
Use bits 10, 11, and 12 of output word 3 to indicate which of the six
blocks to read. Refer to Appendix A and D.
Remember that result block addresses for the Color CVIM start with
Block 01.
!
ATTENTION: To ensure that your results data is current and
valid, you should use programming logic which synchronizes the
transfer of data when inspections occur.
Use the Data Valid bits of input word 0 (bit 6) to detect when new
inspection results are available. These bits are described in Chapter 3
(Local I/O).
Note: Later in this chapter we provide an example PLC program for
retrieving results data.