Rockwell Automation 5370 Color CVIM Communications Manual - Manual (Page 79)

Chapter 5
Using the RS–232 Ports
5–11
Use the load command to transfer configuration data to the Color CVIM
module’s RAM. Use one of the following commands:
> LO [CR] Transfers configuration from the
EEPROM to the Color CVIM module
internal RAM.
> LO,CC,1 [CR] Transfers memory from the RAM Card
area 1 memory to the Color CVIM module
internal RAM.
> LO,CC,2 [CR] Transfers memory from the RAM Card
area 2 memory to the Color CVIM module
internal RAM.
This function can only be executed once per command. You cannot use this
command when the Color CVIM module is in the SETUP mode.
After executing a command, the Color CVIM module will return: [CR][LF].
No data is returned by the command. If you do not have the proper command
structure or the Color CVIM module is in the SETUP mode, the Color CVIM
module will return: ?[CR][LF].
Loading Configurations