Metrohm 815 Robotic Soliprep - Manual (Page 139)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
5 Controlling the Polytron ®
815 Robotic Soliprep
￭￭￭￭￭￭￭￭ 131
￭ Terminator for receive = \0D (= CR)
￭ Code page = ASCII
6 Click on [Connect].
In the dialog window of the connection test, you can check the data
transfer to the Polytron by sending a command to the device. A list
of possible commands can be found below, see page 132.
7 Close the window with [OK] and then quit the configuration dialog
with [OK].
Control
The Polytron can be switched on and off with the communications com-
mand TRANSFER. Subsequently, the rotational speed of the aggregate
can also be set (in revolutions per minute).
The control commands for the Polytron are comprised of a three-digit
numerical code.
A TRANSFER command for switching on the device could look as follows: