Metrohm 815 Robotic Soliprep - Manual (Page 70)

3.1 Installation
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
62 ￭￭￭￭￭￭￭￭
815 Robotic Soliprep
5
5 Press on the pressure clamp and clamp tightly with the locking lever.
Tighten the clamping screw until the pump tubing cannot shift posi-
tion. The flow rate of the pump can be adjusted later with the
clamping screw while the pump is running.
6 Connect the connection cable of the pump to tower 2.
￭ Plug the threaded plug of the connection cable into the connec-
tion socket Ext. Pump 2 on the rear of the tower.
Correct alignment of the 3 contact pins must be observed.
￭ Tighten the knurled screw at the front end of the plug by hand in
clockwise direction. This will secure the plug.