Leica Geosystems TPS1100 Professional Series - System Field Manual - Manual (Page 43)

43
FNC\ Function selection
MC
Increment & Offset This dialog allows to define the increment of the point Id. The
Cross, length and/ or elevation offsets can be defined for any target
point, too.
Call the Increment & Offset dialog from the Function selection
dialog.
Enter the point Id increment and the starting point ID in order to
increase the running point no. after every record.
For instance: Increment = 10; starting point Id = 200; point Id's are
210, 220, 230, 240, etc.
Increment
FNC\ Increment & Offset.
Point Id : 200
Increment : 10
Offs.Cross : 0.000 m
Offs.Lngth : 0.000 m
Offs.Elev. : 0.000 m
Offs.Mode : Reset after REC
CONT OFS=0
MC
Reset offset values to zero