Leica Geosystems TPS1100 Professional Series - System Field Manual - Manual (Page 93)

93
Switch ON and measure with
Quick Coding
You can switch ON/OFF the Quick Code function in the
measurement dialog.
To switch ON Quick Coding. The symbol “C” is displayed as long
Quick Coding is switched ON.
The function is visible only if a codelist with short cuts have
been selected.
Enter the short cut number on the numeric keypad to start the
combined ALL/CODE sequence.
You can use all functions keys available in the measurement dialog
while Quick Coding is active.
You can edit values (e.g. Point Id). You need to position first the
cursor bar with the up/down arrow keys, then press
to start the
edit mode for the highlighted value.
F4
Qcod+
F4
Qcod+
Meas\ Measurement & Record
Point Id : 112
Refl. Ht : 1.65 m
Hz : 100.5463 g
V : 99.8889 g
Horiz.Dist : -----m
Elev.Diff. : -----m
MC
ALL DIST REC QCOD+ HZ0 DSP
C