Leica Geosystems TPS1100 Professional Series - System Field Manual - Manual (Page 96)

96
Manual point code entry
Point code entry in the measurement dialog:
To toggle the display mask until Point Code and Attributes
are displayed as shown below:
Enter the point code and up to 8 attribute values.
To simultaneously measure a distance, record the measurement
data, the point code and the attribute values.
To record the measurement data, the point code and attribute
values.
The entered point code and its attributes will be recorded
everytime
or are pressed.
The point code and attributes are recorded together with the
measurement data in the GSI measurement block as WI71-WI79 if
defined so in the REC-Mask.
Or
F6
>DISP
Meas\ Measurement & Record
Point Id : 112
Point Code : -----
Attrib. 1 : -----
Attrib. 2 : -----
Attrib. 3 : -----
Attrib. 4 : -----
MC
ALL DIST REC SetHz >DISP
F1
ALL
F3
REC
F1
ALL
F3
REC