Leica Geosystems TPS1100 Professional Series - System Field Manual - Manual (Page 44)

44
Enter Offset values
Enter offset values for the displayed point Id, according to
the sign convention explained in the illustration.
Define corresponding Offset mode:
To accept increment and/or offset values and return to the dialog
from which FNC has been started.
F1
CONT
Reset after REC The entered offset values are reset to zero after
the point has been recorded.
Permanent The entered offset values are applied to all
measurements.
1100QS07
O
ffs.Lngth -
Offs.Cross -
O
ffs.Lngth +
Offs.Cross +
Offset PT.
Elev. +:
Offset point is
higher than
measurement