Leica Geosystems TPS1100 Professional Series - System Field Manual - Manual (Page 94)

94
Quick Coding settings
Access the Quick Coding configuration settings from the
main menu:
MAIN MENU
MC
Conf\ Configuration
MC
Conf\Instrument Config.
MC
Conf\ Point and Meas. Param.
Increment : 1
Quick-Code : REC before ALL
Quick-Code : with one digit
MC
Recording sequence
Short Cut: number of digits
REC before
ALL
Code block recorded before measurement
block.
REC after ALL Code block recorded after measurement block.
with one digit Enter a short cut number with one digit to start
the Quick Coding sequence.
with two digit Enter a short cut number with two digits to start
the Quick Coding sequence.
!
For short cuts with one digit (e.g. 7), you
must first enter a zero, then the
corresponding digit to start the Quick
Coding sequence (e.g. 07).