Leica Geosystems TPS1100 Professional Series - System Field Manual - Manual (Page 71)

71
Functions configuration
Press down the FNC key for more then two seconds, until the
dialog “RCS\ Configuration” is displayed.
RCS\ Configuration
1 Select language
MC
This dialog gives access to following functions:
To select the language to be displayed on the RCS controller.
To select the TPS1100 mode.
To set the serial interface parameters of the RCS controller. They
must correspond to the TPCS26 default settings:
• 19200 baud
• 8 data bits
• No parity
To configure the link number, which must be changed at the same
time on both radio modems. Therefore the TCPS26 must be
connected to the RCS Controller.
> 2 sec.