KEYENCE IL Series - Manual (Page 40)

3-8 IL-E
3
Basic Oper
ations
3-3
Initial Reset (Initialize)
When initial reset is performed, all settings, excluding the calibration function, are initialized.
The judgment output's polarity and analog output setting can be changed with the same operation.
Main screen
1
While pressing the [MODE] button on the main screen,
press the [SET] button 5 times.
[reset] is displayed on the main display (upper level).
While pressing the
[MODE] button,
press the [SET]
button 5 times.
2
Press S/T button to select [yes] and press the
[MODE] button.
If [no] is selected at this point, only the output polarity and analog
output settings can be changed without performing the initial reset.
[MODE] button
3
Press S/T button to select the output polarity and
press the [MODE] button.
[MODE] button
4
Press S/T button to select the analog output and
press the [MODE] button. (only for IL-1000 / IL-1500
only)
"10. Analog Output Scaling" (page 4-27)
[MODE] button
5
After the initialization is complete, [end] blinks several
times on the sub display and the main screen is restored.
Point
If the calculation function is used, perform the initial reset for the
main unit first.
Reference
• When buttons other than the S/T button and [MODE] button are pressed
during the initial reset procedure, the initial reset is canceled and the
screen in step 2 is restored.
• When you attempt to initialize the unit while the key
lock function is set, the screen shown on the right
appears and the initialization fails.
Cancel the key lock before attempting to initialize the unit.
"3-7 Key Lock Function" (page 3-21)

LASER
BANK 0 1 2 3
HI
GO
LO
R.V. ANALOG
HI SHIFT
ZERO SHIFT
TIMING LO
ALIGNMENT
 HOLD CALC CHECK
;GU
LASER
BANK 0 1 2 3
HI
LO
R.V. ANALOG
HI SHIFT
ZERO SHIFT
TIMING LO
ALIGNMENT
T'5'V
GO
HOLD CALC CHECK
Performing the initial reset
PRP
LASER
BANK 0 1 2 3
HI
LO
R.V. ANALOG
HI SHIFT
ZERO SHIFT
TIMING LO
ALIGNMENT
QWV
GO
HOLD CALC CHECK
Output polarity Setting value Description
npn
NPN output
pnp
PNP output
QHH
LASER
BANK 0 1 2 3
HI
LO
R.V. ANALOG
HI SHIFT
ZERO SHIFT
TIMING LO
ALIGNMENT
#P.)
GO
HOLD CALC CHECK
Analog output
Setting value Description
off
Not output
0-5 u
Analog output after the judgment value is converted to the range from 0 to 5 V.
-5-5 u
Analog output after the judgment value is converted to the range from -5 to 5 V.
1-5 u
Analog output after the judgment value is converted to the range from 1 to 5 V.
aMpr
Analog output after the judgment value is converted to the range from 4 to 20 mA.
'PF
LASER
BANK 0 1 2 3
HI
LO
R.V. ANALOG
HI SHIFT
ZERO SHIFT
TIMING LO
ALIGNMENT
T'5'V
GO
HOLD CALC CHECK
LASER
BANK 0 1 2 3
HI
LO
R.V. ANALOG
HI SHIFT
ZERO SHIFT
TIMING LO
ALIGNMENT
.QE
GO
HOLD CALC CHECK